INTRUSION SENSOR CANCEL SWITCH INSPECTION

PROCEDURE


  1. INSPECT INTRUSION SENSOR CANCEL SWITCH (MAP LIGHT ASSEMBLY)


    1. A001WGIC02
      *a

      Component without harness connected

      (Intrusion Sensor Cancel Switch (Map Light Assembly))

      Check the resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        11 (SOFF) - 3 (GND) Intrusion sensor cancel switch is pressed Below 1 Ω
        11 (SOFF) - 3 (GND) Intrusion sensor cancel switch is not pressed 10 kΩ or higher

        If the resistance is not as specified, replace the intrusion sensor cancel switch (map light assembly).