UNLOCK WARNING SWITCH INSPECTION

PROCEDURE


  1. INSPECT UNLOCK WARNING SWITCH ASSEMBLY


    1. A001YEJC03
      *a

      Component without harness connected

      (Unlock Warning Switch Assembly)
      *b Not Pushed
      *c Pushed

      Check the resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        1 (UN+) - 2 (UN-) Pushed Below 1 Ω
        1 (UN+) - 2 (UN-) Not Pushed 10 kΩ or higher

        If the result is not as specified, replace the unlock warning switch assembly.