GENERATOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures(adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the generator assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Simple intelligent parking assist system*1

Click here

Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Initialize back door lock Power door lock control system

Click here

*1: When performing learning using the GTS.
Click here Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FAN AND GENERATOR V BELT

    Click here

  4. REMOVE GENERATOR ASSEMBLY


    1. A001SUC

      Remove the terminal cap from the generator assembly.

    2. Remove the nut to disconnect the engine wire from terminal B.

    3. Disconnect the generator assembly connector.

    4. Disengage the clamp to disconnect the wire harness from the wire harness clamp bracket.

    5. A001SF5

      Remove the 2 bolts and generator assembly.

    6. A001SYI

      Remove the bolt and wire harness clamp bracket from the generator assembly.