GENERATOR(for VALEO Made) DISASSEMBLY

PROCEDURE


  1. REMOVE GENERATOR PULLEY CAP


    1. A001TAN

      Using a screwdriver, remove the generator pulley cap from the generator pulley with clutch.

      Note

      Do not reuse the generator pulley cap.

  2. REMOVE GENERATOR PULLEY WITH CLUTCH


    1. Secure the generator drive end frame in a vise between aluminum plates.

      Note

      Do not overtighten the vise.

    2. A001Y82C01
      *1 Generator Pulley with Clutch

      Fit SST to the generator pulley with clutch.

      SST
      09820-30010
    3. A001XPWC01
      *a Rotor Shaft
      *b T45 "TORX" Socket Wrench

      Fit a T45 "TORX" socket wrench into the rotor shaft end.

    4. A001VJ1C01
      *a T45 "TORX" Socket Wrench
      *b Turn
      *c Hold

      Loosen the generator pulley with clutch by turning the T45 "TORX" socket wrench as shown in the illustration.

      Note


      • Check that the generator assembly is secured in the vise tightly.

      • Hold SST tightly during the operation.

    5. Remove SST and the T45 "TORX" socket wrench from the generator pulley with clutch.

    6. Remove the generator pulley with clutch from the rotor shaft.

    7. Remove the generator assembly from the vise.