BLIND SPOT MONITOR SYSTEM CUSTOMIZE PARAMETERS


  1. CUSTOMIZE BLIND SPOT MONITOR SYSTEM


    1. Customizing with the GTS

      Note


      • When the customer requests a change in a function, first make sure that the function can be customized.

      • Be sure to make a note of the current settings before customizing.

      • When troubleshooting a function, first make sure that the function is set to the default setting.


      1. Connect the GTS to the DLC3.

      2. Turn the ignition switch to ON.

      3. Turn the blind spot monitor system on.

      4. Turn the GTS on.

      5. Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Utility / Warning.

      6. Select the setting by referring to the table below.


        Warning
        Tester Display Description Default Setting ECU
        BSM Buzzer Volume Adjust Sets the volume of the RCTA buzzer (blind spot monitor buzzer). Medium 001:Low,011:Medium,101:High Blind Spot Monitor Sensor LH (Master)
        BSM Mirror Indicator Brightness Sets the brightness of the indicators in the outer rear view mirror assemblies. Bright 001:Dark,101:Bright Blind Spot Monitor Sensor LH (Master)
        RCTA Function Switches the RCTA function on and off. ON 0:ON,1:OFF Blind Spot Monitor Sensor RH (Slave)