TELEPHONE ANTENNA CORD REMOVAL

Info Added 2017-10-06

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the telephone antenna cord removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system

Click here

Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system

Click here

*1: When performing learning using the GTS.

Click here

*2: w/ Stop and start system

PROCEDURE


  1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  2. REMOVE NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY

    Click here

  3. REMOVE ROOF HEADLINING

    Click here

  4. REMOVE ANTENNA CORD SUB-ASSEMBLY


    1. A001SE0

      Disengage the guides to remove the antenna cord sub-assembly.

  5. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY


    1. Type A:


      1. Remove the adhesive tape from the roof headlining.

        A001VVFC01
        B004987 Adhesive Tape B0049DE Front

      2. Disengage the clamp and notch to remove the No. 2 antenna cord sub-assembly from the roof headlining.

    2. Type B:


      1. Remove the adhesive tape from the roof headlining.

        A001V4UC03
        B004987 Adhesive Tape B0049DE Front

      2. Disengage the clamp and notch to remove the No. 2 antenna cord sub-assembly from the roof headlining.

  6. REMOVE NO. 3 ANTENNA CORD SUB-ASSEMBLY


    1. A001SBKC01
      *a Clamp
      *b Guide

      Disconnect the connector.

    2. Remove the bolt.

    3. Using a clip remover, disengage the clamps and guide to remove the No. 3 antenna cord sub-assembly.