NOISE FILTER REMOVAL

PROCEDURE

1. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)

   Click here

2. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

   Click here

3. REMOVE DECK BOARD ASSEMBLY (w/ Deck Board)

   Click here

4. REMOVE SPARE WHEEL CUSHION (w/ Deck Board)

   Click here

5. REMOVE DECK FLOOR BOX LH (w/ Deck Floor Box)

   Click here

6. REMOVE DECK FLOOR BOX RH (w/ Deck Floor Box)

   Click here

7. REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY

   Click here

8. REMOVE REAR DOOR SCUFF PLATE LH

   Click here

9. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH

   Click here

10. REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY LH

    Click here

11. REMOVE REAR SEAT SIDE GARNISH LH

    Click here

12. REMOVE DECK TRIM REAR COVER

    Click here

13. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (w/ Luggage Compartment Room Light)

    Click here

14. REMOVE DECK TRIM SIDE COVER LH (w/ Cover)

    Click here

15. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

16. REMOVE RADIO SETTING CONDENSER

    Note

    When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.

    
    

    1. 

       Remove the bolt.

    2. Disengage the clamp to disconnect the radio setting condenser with wire harness from the vehicle body.

    3. 

       Using a screwdriver, disengage the claws to remove the terminal cover with wire harness from the condenser.

    4. 

       Using a screwdriver, bend back and break off the claw as shown in the illustration.

    5. Remove the terminal cover from the wire harness.

       Note

       
       

       • Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

       • Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

       • Check for deformation of the terminal after the wire harness has been removed from the terminal cover.