STEREO COMPONENT AMPLIFIER REMOVAL

Info Added 2017-10-06

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the stereo component amplifier assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system

Click here

Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system

Click here

*1: When performing learning using the GTS.

Click here

*2: w/ Stop and start system

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

B00495G

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY LH

    Click here

  2. REMOVE AUDIO AMPLIFIER COVER


    1. A001SAYC01
      B00497S Remove in this Direction (1)
      B0049AC Remove in this Direction (2)

      Pull the audio amplifier cover in the direction indicated by the arrow (1) shown in the illustration to disengage the clips.

    2. Pull the audio amplifier cover in the direction indicated by the arrow (2) shown in the illustration to disengage the guide to remove the audio amplifier cover.

  3. REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY WITH BRACKET


    1. A001VLB

      Disengage the clamp.

    2. Disconnect the connector.

    3. A001Y9PC02
      *a Lock Lever
      B00497S Remove in this Direction

      Disengage the claw and pull the lock lever to disconnect the connector as shown in the illustration.

    4. A001SDB

      Turn back the part of the front floor carpet assembly.

    5. Remove the 2 bolts and remove the stereo component amplifier assembly with bracket.

  4. REMOVE NO. 2 AMPLIFIER BRACKET


    1. A001SPM

      Remove the 2 screws and No. 2 amplifier bracket from the stereo component amplifier assembly.

  5. REMOVE NO. 1 AMPLIFIER BRACKET


    1. A001W6J

      Remove the 2 screws and No. 1 amplifier bracket from the stereo component amplifier assembly.