REAR BRAKE REASSEMBLY

Info Added 2017-10-06

PROCEDURE


  1. TEMPORARILY TIGHTEN REAR DISC BRAKE BLEEDER PLUG


    1. Temporarily install the rear disc brake bleeder plug to the rear disc brake cylinder assembly.

      Tech Tips

      Fully tighten the rear disc brake bleeder plug after bleeding the system.

  2. INSTALL REAR DISC BRAKE BLEEDER PLUG CAP


    1. Install the rear disc brake bleeder plug cap to the rear disc brake bleeder plug.

  3. INSTALL PISTON SEAL


    1. A001XOYC02
      B004987 Lithium Soap Base Glycol Grease

      Apply lithium soap base glycol grease to the entire circumference of a new piston seal.

    2. Install the piston seal to the rear disc brake cylinder assembly.

      Note


      • Do not damage the inner surface or piston seal groove of the rear disc brake cylinder.

      • Do not allow the nut to rotate. If the nut is accidentally allowed to rotate, return it to its original position.

  4. INSTALL REAR DISC BRAKE PISTON


    1. A001UTHC01
      *1 Cylinder Boot
      *2 Rear Disc Brake Piston
      B004987 Lithium Soap Base Glycol Grease

      Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot.

    2. Apply a light layer of lithium soap base glycol grease to the contact surfaces of the rear disc brake piston.

    3. A001UB1C01
      *a Front Side
      *b Back Side

      Install the cylinder boot to the rear disc brake piston.

      Note

      The front and back sides of the cylinder boot are different. Make sure not to install the cylinder boot backwards.

    4. A001UXEC01
      *a Indentations

      Install the rear disc brake piston to the rear disc brake cylinder assembly.

      Note


      • Install the rear disc brake cylinder LH so that its portions marked (A) fit into the indentations of the rear disc brake piston.

      • Do not forcibly install the rear disc brake piston into the rear disc brake cylinder assembly.

    5. A001U4BC01
      *1 Cylinder Boot
      *2 Rear Disc Brake Cylinder Assembly
      *3 Rear Disc Brake Piston

      Install the cylinder boot to the rear disc brake cylinder assembly as shown in the illustration.

      Note


      • Do not damage the cylinder boot.

      • Securely install the cylinder boot into the groove of the rear disc brake cylinder assembly and groove of the rear disc brake piston.