VACUUM PUMP(for 3ZR-FAE) INSTALLATION

Info Added 2017-10-06

PROCEDURE


  1. INSTALL VACUUM PUMP ASSEMBLY


    1. When installing a new vacuum pump assembly:


      1. A005OF2C01
        *1 No. 2 O-ring
        *2 No. 3 O-ring

        Apply engine oil to the No. 2 O-ring and No. 3 O-ring which are installed to a new vacuum pump assembly.

    2. When reusing the vacuum pump assembly:


      1. A005OF2C01
        *1 No. 2 O-ring
        *2 No. 3 O-ring

        Apply engine oil to a new No. 2 O-ring and No. 3 O-ring and install them to the vacuum pump assembly.

    3. A005PPTC01
      *a Coupling Teeth
      *b Groove
      B00495X Engine Oil

      Apply engine oil to the inner surface of the installation hole.

    4. Install the vacuum pump assembly so that the coupling teeth of the vacuum pump assembly and the groove of the camshaft are engaged.

      Note

      Ensure that the vacuum pump assembly is installed securely.

    5. A005Q6ON01

      Install the 3 bolts.

      Torque:
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

      Note

      After tightening the bolts, ensure that the contact surface of the vacuum pump assembly is flush with the cylinder head.

      Tech Tips

      Length of the Bolt
      Bolt A 25 mm (0.984 in.)
      Bolt B 45 mm (1.77 in.)

    6. Connect the union to connector tube hose to the vacuum pump assembly and slide the clip to secure it.

  2. CONNECT UNION TO CONNECTOR TUBE HOSE


    1. Connect the union to connector tube hose to the vacuum pump assembly and slide the clip to secure it.

  3. CONNECT ENGINE WIRE

    Click here

  4. INSTALL NO. 2 CYLINDER HEAD COVER

    Click here

  5. INSTALL BATTERY

    Click here

  6. OPERATION CHECK

    Click here