BRAKE PEDAL(for LHD) REMOVAL

Info Added 2017-10-06

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the brake pedal support assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system

Click here

Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system

Click here

*1: When performing learning using the GTS.

Click here

*2: w/ Stop and start system

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

B00495G

PROCEDURE


  1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  2. REMOVE STOP LIGHT SWITCH ASSEMBLY

    Click here

  3. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

  4. REMOVE BRAKE PEDAL RETURN SPRING


    1. A001VIY

      Remove the brake pedal return spring from the brake pedal support assembly and push rod pin.

  5. REMOVE PUSH ROD PIN


    1. A001VOT

      Remove the clip and push rod pin to separate the brake pedal support assembly from the brake master cylinder push rod clevis.

  6. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


    1. w/ Brake pedal Load Sensing Switch:


      1. A001SIC

        Disconnect the brake pedal load sensing switch connector.

      2. Disengage the clamp to separate the wire harness from the brake pedal support assembly.

    2. A001V4ZC01

      Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement assembly.

    3. A001Y2T

      Remove the 2 clips.

    4. Remove the 4 nuts and brake pedal support assembly.

    5. A001WOR

      Remove the nut from the brake pedal support assembly.

  7. REMOVE BRAKE PEDAL PAD


    1. Remove the brake pedal pad from the brake pedal support assembly.