BRAKE HOLD SWITCH INSPECTION

PROCEDURE


  1. INSPECT BRAKE HOLD SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)


    1. Check the resistance.


      1. A001VIDC06
        *a

        Component without harness connected

        (Brake Hold Switch (Electric Parking Brake Switch Assembly))

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        12 (+B) - 8 (E) Switch pushed Below 1 Ω
        12 (+B) - 8 (E) Switch not pushed 10 kΩ or higher

        If the result is not as specified, replace the brake hold switch (electric parking brake switch assembly).