VEHICLE STABILITY CONTROL SYSTEM ABS Warning Light does not Come ON

DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.

CAUTION / NOTICE / HINT

Note

When replacing the skid control ECU (brake actuator assembly), perform system variant learning.

Click here

PROCEDURE


  1. CHECK CAN COMMUNICATION SYSTEM


    1. Check if CAN communication system DTCs are output.

      Click here

      Result
      Result Proceed to
      DTCs are not output. A
      DTCs are output. B

    B

    INSPECT CAN COMMUNICATION SYSTEM Click here

    A

  2. PERFORM ACTIVE TEST USING GTS (ABS WARNING LIGHT)


    1. Select the Active Test on the GTS.

      Click here


      Chassis > ABS/VSC/TRC/EPB > Active Test
      Tester Display Measurement Item Control Range Diagnostic Note
      ABS Warning Light ABS warning light Warning light ON/OFF Observe combination meter assembly

      Chassis > ABS/VSC/TRC/EPB > Active Test
      Tester Display
      ABS Warning Light

    2. Select the Data List on the GTS.

      Click here


      Chassis > ABS/VSC/TRC/EPB > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      ABS Warning Light ABS warning light ON or OFF

      ON: Warning light on

      OFF: Warning light off

      		 -

      Chassis > ABS/VSC/TRC/EPB > Data List
      Tester Display
      ABS Warning Light

    3. Check the operating condition of the ABS warning light when operating it using the GTS.

      Result
      Result Proceed to
      ABS warning light in the Data List does not change using the Active Test. (for LHD) A
      ABS warning light in the Data List does not change using the Active Test. (for RHD) B
      ABS warning light in the Data List turns ON/OFF using the Active Test. C

    A

    REPLACE BRAKE ACTUATOR ASSEMBLY Click here

    B

    REPLACE BRAKE ACTUATOR ASSEMBLY Click here

    C

  3. INSPECT COMBINATION METER ASSEMBLY


    1. Perform the Active Test of the combination meter assembly using the GTS.

      Click here


      Body Electrical > Combination Meter > Active Test
      Tester Display
      Indicat. Lamp ABS

    2. Check the combination meter assembly.

      OK
      The ABS warning light turns on or off in accordance with GTS operation.
      Result
      Result Proceed to
      OK (for LHD) A
      OK (for RHD) B
      NG C

    A

    REPLACE BRAKE ACTUATOR ASSEMBLY Click here

    B

    REPLACE BRAKE ACTUATOR ASSEMBLY Click here

    C

    INSPECT METER / GAUGE SYSTEM Click here