REAR DIFFERENTIAL CARRIER ASSEMBLY INSTALLATION

PROCEDURE

INSTALL ELBOW TUBE
1. *a 48 to 51°
  
  Install a new elbow tube to the differential carrier sub-assembly as shown in the illustration.
  
  Note
  
  Press fit until the edge of the bulge spool.
INSTALL REAR DIFFERENTIAL SUPPORT
1. Install the rear differential support to the rear differential carrier assembly with 4 new bolts.
  
  Torque:
  
  72 N*m { 734 kgf*cm, 53 ft.*lbf }
INSTALL REAR NO. 1 DIFFERENTIAL SUPPORT
1. Install the rear No. 1 differential support to the rear differential carrier assembly with 2 new bolts.
  
  Torque:
  
  55 N*m { 561 kgf*cm, 41 ft.*lbf }
INSTALL REAR NO. 2 DIFFERENTIAL SUPPORT
1. Install the rear No. 2 differential support to the rear differential carrier assembly with 2 new bolts.
  
  Torque:
  
  55 N*m { 561 kgf*cm, 41 ft.*lbf }
INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY
1. Support the rear differential carrier assembly with a transmission jack or equivalent.
2. Slowly raise the transmission jack, and install 3 new bolts.
  
  Torque:
  
  for bolt A
  
  86 N*m { 877 kgf*cm, 63 ft.*lbf }
  
  for bolt B
  
  106 N*m { 1080 kgf*cm, 78 ft.*lbf }
3. Install the breather tube.
4. Install the wire harness clamp bracket with the bolt.
  
  Torque:
  
  19.6 N*m { 200 kgf*cm, 14 ft.*lbf }
5. Connect the connector.
6. Connect the 2 harness clamps.
INSTALL MAIN MUFFLER HEAT INSULATOR
1. Install the main muffler heat insulator to the vehicle body with the 4 nuts.
  
  Torque:
  
  5.0 N*m { 51 kgf*cm, 44 in.*lbf }
INSTALL REAR DRIVE SHAFT ASSEMBLY LH
- for TMC Made: Click here
- for TMMT Made: Click here
INSTALL REAR DRIVE SHAFT ASSEMBLY RH

Tech Tips

Use the same procedure described for the LH side.
INSTALL REAR STABILIZER BAR

Click here
INSTALL NO. 1 FUEL TANK PROTECTOR SUB-ASSEMBLY

Click here
INSTALL NO. 2 FUEL TANK PROTECTOR

Click here
INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

Click here
ADD DIFFERENTIAL OIL

Click here
INSTALL REAR WHEEL

Click here