REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL REPLACEMENT

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear drive shaft oil seal LH removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear wheel alignment adjustment

  1. Clear zero point calibration data.

  2. Perform yaw rate and acceleration sensor zero point calibration.

  • DTCs are stored

  • ABS warning light illuminates

  • Slip indicator light illuminates

  • VSC disabled or malfunctions

Click here


  • Rear height control sensor sub-assembly LH*1

  • Suspension, tires, etc.

    (The vehicle height changes because of suspension or tire replacement)

 Initialize No. 1 headlight ECU sub-assembly LH Automatic headlight beam level control system

Click here


Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE REAR DRIVE SHAFT ASSEMBLY LH


  2. REMOVE REAR DRIVE SHAFT OIL SEAL LH


    1. A005PFKN01

      Using SST, tap out the rear drive shaft oil seal LH.

      SST
      09308-00010

      Note

      Be careful not to damage the rear differential carrier sub-assembly.

  3. INSTALL REAR DRIVE SHAFT OIL SEAL LH


    1. Coat the lip of a new rear drive shaft oil seal LH with MP grease.

    2. A005PCIC01
      *a Depth

      Using SST and a hammer, install the rear drive shaft oil seal LH to the rear differential carrier sub-assembly.

      SST
      09223-00010
      Standard Depth
      6.7 to 7.7 mm (0.264 to 0.303 in.)

      Note


      • Tap the oil seal uniformly so that the oil seal is straight.

      • Do not tap the oil seal in too far.

  4. INSTALL REAR DRIVE SHAFT ASSEMBLY LH