REAR DRIVE SHAFT ASSEMBLY(for TMC Made) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR DRIVE SHAFT INBOARD JOINT SHAFT SNAP RING LH


    1. Install a new rear drive shaft inboard joint shaft snap ring LH.

  2. INSTALL REAR DRIVE SHAFT ASSEMBLY LH


    1. Coat the splines of the rear drive inboard joint assembly LH with Toyota Genuine Differential Gear Oil LT.

    2. A001XQO

      Align the inboard joint splines, and using a brass bar and a hammer, install the rear drive shaft assembly.

      Note


      • Face the end gap of the rear drive shaft inboard joint shaft snap ring LH downward.

      • Do not damage the rear drive shaft oil seal.

      • Do not damage the rear drive shaft inboard joint boot LH.

      • Make sure to center the rear drive shaft assembly during installation to prevent damage to the rear drive shaft inboard joint shaft snap ring LH.

      Tech Tips

      Confirm whether the drive shaft is securely driven in by checking the reaction force and sound.

  3. INSTALL REAR AXLE CARRIER ASSEMBLY

    Click here

  4. ADD DIFFERENTIAL OIL

    Click here

  5. INSPECT FOR DIFFERENTIAL OIL LEAK