FRONT DRIVE SHAFT ASSEMBLY(for TMC Made) INSPECTION

PROCEDURE


  1. INSPECT FRONT DRIVE SHAFT ASSEMBLY


    1. A001YAN

      Check that there is no excessive play in the radial direction of the outboard joint.

    2. Check that the inboard joint slides smoothly in the thrust direction.

    3. Check that there is no excessive play in the radial direction of the inboard joint.

    4. Check the boots for damage.

    5. A001UWDE01

      Check whether each drive shaft dimension (A) is within specification.

      Dimension (A)
      LH Side 615.9 mm (2.02 ft.)

      RH Side

      (for 2WD)

      		 870.9 mm (2.86 ft.)

      RH Side

      (for AWD)

      		 876.5 mm (2.88 ft.)

      Note

      Keep the front drive shaft assembly level during inspection.