OIL PRESSURE SENSOR INSTALLATION

PROCEDURE

1. INSTALL OIL PRESSURE SENSOR

   
   

   1. Apply Toyota Genuine CVT fluid FE to a new O-ring of the oil pressure sensor.

      Note

      If reusing the oil pressure sensor, check that the O-ring is not damaged.

   2. 

      *a	Torque Wrench Fulcrum Length

      Using SST, install the oil pressure sensor to the continuously variable transaxle assembly.

      SST

      09326-22011

      Torque:

      Specified Tightening Torque

      20.6 N*m  { 210 kgf*cm, 15 ft.*lbf }

      Tech Tips

      
      

      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 50 mm (1.97 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 16.1 N*m (164 kgf*cm, 12 ft.*lbf)

   3. Connect the oil pressure sensor connector.

2. INSPECT FOR CONTINUOUSLY VARIABLE TRANSAXLE FLUID LEAK

3. INSTALL REAR ENGINE UNDER COVER LH

   Click here

4. INSTALL NO. 1 ENGINE UNDER COVER

   Click here

5. INSTALL FRONT WHEEL LH

   Click here

6. RESET MEMORY

   Click here