OIL COOLER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission oil cooler removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of CVT fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly

Click here

PROCEDURE


  1. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  2. REMOVE REAR ENGINE UNDER COVER LH

    Click here

  3. DRAIN ENGINE COOLANT

    Click here

  4. DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID

    Click here

  5. REMOVE TRANSMISSION OIL COOLER


    1. A001WF6C01
      *1 No. 3 Water By-pass Hose
      *2 No. 4 Water By-pass Hose

      Slide the 2 clips and disconnect the No. 3 water by-pass hose and No. 4 water by-pass hose from the transmission oil cooler.

    2. A001V78

      Remove the 3 bolts and transmission oil cooler from the continuously variable transaxle assembly.

    3. Remove the 2 O-rings from the transmission oil cooler.