REVOLUTION SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission revolution sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point

  • Lane departure alert system (w/ Steering Control)

  • Simple intelligent parking assist system*1

  • Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1

  • Pre-collision system

Click here

Initialize back door lock Power door lock control system

Click here


PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE BATTERY

    Click here

  4. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  5. REMOVE RADIATOR COVER

    Click here

  6. REMOVE NO. 1 AIR CLEANER INLET

    Click here

  7. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

    Click here

  8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  9. REMOVE ECM

    Click here

  10. REMOVE BATTERY CLAMP SUB-ASSEMBLY

    Click here

  11. REMOVE TRANSMISSION REVOLUTION SENSOR (NIN)

    A001XOS

    1. Disconnect the connector.

    2. Remove the bolt and transmission revolution sensor (NIN) from the continuously variable transaxle assembly.

    3. Remove the O-ring from the transmission revolution sensor (NIN).

  12. REMOVE TRANSMISSION REVOLUTION SENSOR (NOUT)

    A001V5S

    1. Disconnect the connector.

    2. Remove the bolt and transmission revolution sensor (NOUT) from the continuously variable transaxle assembly.

    3. Remove the O-ring from the transmission revolution sensor (NOUT).

  13. REMOVE TRANSMISSION REVOLUTION SENSOR (NT)

    A001TUD

    1. Disconnect the connector.

    2. Remove the bolt and transmission revolution sensor (NT) from the continuously variable transaxle assembly.

    3. Remove the O-ring from the transmission revolution sensor (NT).