OIL PAN REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transaxle oil (CVT) pan sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of CVT fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly

Click here

PROCEDURE


  1. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  2. REMOVE REAR ENGINE UNDER COVER LH

    Click here

  3. REMOVE TRANSAXLE OIL (CVT) PAN SUB-ASSEMBLY


    1. A001XMA

      Remove the refill plug and gasket from the continuously variable transaxle assembly.

    2. A001Y8O

      Using a 10 mm hexagon socket wrench, remove the drain plug and gasket from the transaxle oil (CVT) pan sub-assembly, and drain the fluid.

    3. A001TNR

      Using a 6 mm hexagon socket wrench, remove the overflow plug and gasket from the transaxle oil (CVT) pan sub-assembly.

    4. A001V2PC02
      *1 No. 1 Transmission Oil Filler Tube

      Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler tube from the transaxle oil (CVT) pan sub-assembly.

      Tech Tips

      Removing the No. 1 transmission oil filler tube will drain all oil in the transaxle oil (CVT) pan sub-assembly.

    5. A001SSD

      Remove the 19 bolts, transaxle oil (CVT) pan sub-assembly and transaxle oil pan (CVT) gasket from the continuously variable transaxle assembly.

      Note

      Some fluid will remain in the transaxle oil (CVT) pan sub-assembly. Remove all the bolts, and carefully remove the transaxle oil (CVT) pan sub-assembly.

    6. Temporarily install the gasket and refill plug to the continuously variable transaxle assembly.

      Tech Tips

      Reuse the old gasket as the refill plug will be removed again to adjust the fluid level.

  4. REMOVE OIL CLEANER (CVT) MAGNET


    1. A001XQEC02
      *1 Oil Cleaner (CVT) Magnet

      Remove the 2 oil cleaner (CVT) magnets from the transaxle oil (CVT) pan sub-assembly.

    2. Clean off any metal particles adhered to the 2 oil cleaner (CVT) magnets.

    3. Clean the transaxle oil (CVT) pan sub-assembly and remove any metal particles, sludge, etc.