BACK-UP LIGHT SWITCH INSTALLATION

PROCEDURE

1. INSTALL BACK-UP LIGHT SWITCH ASSEMBLY

   
   
   1. 

      *a	27 mm Deep Socket Wrench

      Using a 27 mm deep socket wrench, install a new gasket and the back-up light switch assembly to the manual transaxle assembly.

      Torque:

      40.2 N*m  { 410 kgf*cm, 30 ft.*lbf }

   2. Connect the back-up light switch assembly connector.

2. INSTALL BATTERY CLAMP SUB-ASSEMBLY

   Click here

3. INSTALL ECM

   Click here

4. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

   Click here

5. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

   Click here

6. INSTALL NO. 1 AIR CLEANER INLET

   Click here

7. INSTALL RADIATOR COVER

   Click here

8. INSTALL BATTERY

   Click here

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Click here

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here