TRANSMISSION CONTROL CABLE INSTALLATION

PROCEDURE


  1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Pass the transmission control cable assembly into the vehicle and install the transmission control cable assembly to the vehicle body with the 2 nuts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    2. Engage the guide and connect the transmission control cable assembly to the vehicle body.

    3. Install the nut.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }
    4. A005OOUC01
      *a Paint Mark

      Install the transmission control cable assembly to the control cable bracket assembly with 2 new clips B.

      Note

      Make sure that the paint marks on the transmission control cable assembly are aligned with the slits in the control cable bracket assembly before installing the clips.

    5. Connect the transmission control cable assembly to the manual transaxle assembly with the 2 clips A.

    6. A001SMRC04
      *1 Lock Piece
      *2 Stopper
      *3 Adjuster Case
      *a Twist the stopper
      *b Pull out
      *c Return the stopper

      Release the lock of the transmission control select cable length adjustment structure.


      1. Twist the stopper.

      2. Pull the lock piece outward from the adjuster case to release the lock.

      3. Return the stopper.

    7. Engage the 2 claws to connect the transmission control cable assembly to the floor shift lever assembly.

    8. Connect the transmission control shift cable to the floor shift lever assembly.

    9. A001WRX

      Connect the transmission control select cable to the floor shift lever assembly and install the clip.

      Note


      • Make sure that the lock piece of the transmission control select cable length adjustment structure is facing upward when the transmission control select cable is connected.

      • Make sure that the transmission control select cable is securely installed.

  2. ADJUST TRANSMISSION CONTROL CABLE ASSEMBLY

    Click here

  3. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR


    1. Install the front No. 1 floor heat insulator to the vehicle body with the 3 nuts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  4. INSTALL FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

    Click here

  5. INSTALL FRONT FLOOR CENTER BRACE

    Click here

  6. INSTALL BATTERY CLAMP SUB-ASSEMBLY

    Click here

  7. INSTALL ECM

    Click here

  8. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  9. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  10. INSTALL NO. 1 AIR CLEANER INLET

    Click here

  11. INSTALL RADIATOR COVER

    Click here

  12. INSTALL REAR CONSOLE BOX ASSEMBLY

    Click here

  13. INSTALL BATTERY

    Click here

  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  15. INSPECT FOR EXHAUST GAS LEAK

    Click here

    Tech Tips

    Perform "Inspection After Repairs" after repairing or replacing the exhaust system.

    Click here