MANUAL TRANSAXLE SYSTEM DTC CHECK / CLEAR


  1. CHECK DTC (Using GTS)


    1. DTCs which are stored in the ECM can be output to the GTS.


      1. Connect the GTS to the DLC3.

      2. Turn the ignition switch to ON.

      3. Turn the GTS on.

      4. Enter the following menus: Powertrain / Transmission / Trouble Codes.


        Powertrain > Transmission > Trouble Codes

      5. Confirm the DTCs and freeze frame data, and then write them down.

      6. Confirm the details of the DTCs.

        Click here

  2. CLEAR DTC (Using GTS)


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Transmission / Trouble Codes.

    5. Clear the DTCs.


      Powertrain > Transmission > Clear DTCs

  3. CLEAR DTC (without Using GTS)


    1. Perform either of the following operations.

      Note

      After turning ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

      Click here


      1. Disconnect the cable from the negative (-) battery terminal for more than 1 minute.

      2. Remove the EFI-MAIN NO. 1 and ETCS fuses from the No. 1 engine room relay block located inside the engine compartment for more than 1 minute.