CLUTCH PEDAL SWITCH INSPECTION

PROCEDURE


  1. INSPECT CLUTCH SWITCH ASSEMBLY


    1. Check the resistance.


      1. A001T71C02
        *a

        Component without harness connected

        (Clutch Switch Assembly)
        *b 7.65 to 8.35 mm (0.302 to 0.328 in.)
        *c On
        *d Off

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        1 - 2 On (Pushed in) Below 1 Ω
        Off (Released) 10 kΩ or higher

        If the result is not as specified, replace the clutch switch assembly.