CLUTCH PEDAL(for RHD) INSTALLATION

Info Added 2017-10-06

PROCEDURE


  1. INSTALL CLUTCH PEDAL PAD


    1. Install the clutch pedal pad to the clutch pedal sub-assembly.

  2. INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS BUSH


    1. Install a new clutch master cylinder push rod clevis bush to the clutch pedal sub-assembly.

      Note

      Install the clutch master cylinder push rod clevis bush from the left side of the vehicle.

    2. A001VOLC01
      B00495X MP Grease

      Apply MP grease to the inside of the clutch master cylinder push rod clevis bush.

  3. INSTALL CLUTCH PEDAL SHAFT COLLAR


    1. A001V6HC01
      B00495X MP Grease

      Apply MP grease to both sides of 2 new clutch pedal bushes.

    2. Install the 2 clutch pedal bushes and clutch pedal shaft collar to the clutch pedal sub-assembly.

  4. INSTALL CLUTCH PEDAL TURNOVER BUSH


    1. A001T2CC01
      B00495X MP Grease

      Apply MP grease to the inside of the clutch pedal turnover bush and install the bush to the clutch pedal sub-assembly.

  5. INSTALL CLUTCH PEDAL SPRING HOLDER


    1. A001SNNC01
      B00495X MP Grease

      Apply MP grease to the contact surface of the clutch pedal spring holder and install the clutch pedal spring holder to the clutch pedal support sub-assembly.

  6. INSTALL CLUTCH PEDAL SUB-ASSEMBLY


    1. Install the clutch pedal sub-assembly to the clutch pedal support sub-assembly with the bolt and nut.

      Torque:
      36.8 N*m  { 375 kgf*cm, 27 ft.*lbf }

      Note


      • Install the bolt from the right side of the vehicle.

      • Turn the nut while holding the bolt.

  7. INSTALL CLUTCH PEDAL SPRING


    1. Move the pedal to the full stroke position.

    2. Install the clutch pedal spring to the clutch pedal assembly.

  8. INSTALL CLUTCH PEDAL STROKE SENSOR ASSEMBLY

    Click here

  9. INSTALL CLUTCH SWITCH ASSEMBLY

    Click here

  10. INSTALL CLUTCH PEDAL SUPPORT ASSEMBLY


    1. Install the clutch pedal support assembly to the clutch master cylinder assembly with the 2 nuts.

      Torque:
      12.7 N*m  { 130 kgf*cm, 9 ft.*lbf }

    2. Install the clutch pedal support assembly to the body with the 2 nuts.

      Torque:
      12.7 N*m  { 130 kgf*cm, 9 ft.*lbf }

    3. Engage the 3 clamps to the clutch pedal support assembly.

    4. Connect the 2 connectors.

  11. CONNECT CLUTCH MASTER CYLINDER ASSEMBLY


    1. A001XP6C01
      B00495X MP Grease

      Apply MP grease to the clevis pin.

    2. Connect the clutch master cylinder assembly to the clutch pedal sub-assembly with the clevis pin.

      Note

      Install the clevis pin from the left side of the vehicle.

    3. Install a new clip to the clevis pin.

  12. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here