FRONT CAMERA INSTALLATION

Info Added 2017-10-06

CAUTION / NOTICE / HINT

Note


  • When replacing the forward recognition camera, replace it with a new one.

  • Do not touch the camera lens. If the camera lens has been touched, do not use the forward recognition camera.

  • If the forward recognition camera has been struck or dropped, replace it with a new one.

  • If the forward recognition camera is not properly installed, forward recognition camera optical axis learning cannot be performed properly. Make sure the forward recognition camera is installed securely.

  • Replace the forward recognition camera if there is any foreign matter on the camera lens.

  • When replacing the windshield glass of a vehicle equipped with a forward recognition camera, make sure to use a Toyota genuine part. If a non-Toyota genuine part is used, the forward recognition camera may not be able to be installed due to a missing bracket. Also, the dynamic radar cruise control system, lane departure alert system, pre-collision system, forward recognition camera system or automatic high beam system may not operate properly due to a difference in the transmissivity or black ceramic border.

  • If the forward recognition camera bracket is deformed or damaged, replace it together with the windshield glass.

  • If there is any foreign matter on the area of the windshield glass in front of the forward recognition camera, clean the windshield glass before installing the forward recognition camera.

PROCEDURE


  1. INSTALL FORWARD RECOGNITION HOOD


    1. A005Q2IC01
      B00497S Install in this Direction (1)
      B0049AC Install in this Direction (2)

      Engage the guide and claw as indicated by the arrows, in the order shown in the illustration to install the forward recognition hood.

    2. A005P7YC01
      *A for TMMT Made
      *B for TMC Made

      Engage the clamp to install the forward recognition hood wire to the forward recognition bracket as shown in the illustration.

    3. Connect the connector.

  2. INSTALL FORWARD RECOGNITION CAMERA


    1. A005P5CC01
      *1 Lens Protection Cap

      When using a new forward recognition camera:


      1. Remove the lens protection cap.

        Note

        Do not touch the camera lens after removing the lens protection cap.

    2. A005Q7VC01
      B00497S Install in this Direction

      Engage the 4 guides as shown in the illustration.

      Note

      Do not touch the camera lens.

    3. Connect the connector to install the forward recognition camera.

  3. INSTALL FORWARD RECOGNITION LATCH


    1. A005OU5C01
      B00497S Install in this Direction

      Engage the 4 guides and 2 claws as shown in the illustration to install the forward recognition latch.

  4. INSTALL NO. 1 FORWARD RECOGNITION COVER


    1. A005Q00C01
      B00497S Install in this Direction

      Engage the 2 clips and 2 guides as shown in the illustration to install the No. 1 forward recognition cover.

  5. INSTALL NO. 2 FORWARD RECOGNITION COVER


    1. A005POWC01
      B00497S Install in this Direction (1)
      B0049AC Install in this Direction (2)

      Engage the 2 guides and 2 claws as indicated by the arrows, in the order shown in the illustration to install the No. 2 forward recognition cover.

  6. ADJUST FORWARD RECOGNITION CAMERA


    1. If the forward recognition camera has been replaced with a new one or the windshield glass has been removed and installed, it is necessary to perform Forward Recognition Camera Learning.

      Click here