CRUISE CONTROL MAIN SWITCH REMOVAL

Info Added 2017-10-06

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during cruise control main switch removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point

  • Lane departure alert system (w/ Steering Control)

  • Simple intelligent parking assist system*1

  • Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1

  • Pre-collision system

Click here

Initialize back door lock Power door lock control system

Click here

Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system

Click here


PROCEDURE


  1. REMOVE HORN BUTTON ASSEMBLY

    Click here

  2. REMOVE LOWER NO. 2 STEERING WHEEL COVER


    1. A001VRKC01
      *a Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, disengage the 3 claws and guide to remove the lower No. 2 steering wheel cover.

  3. REMOVE CRUISE CONTROL MAIN SWITCH


    1. A001WR1C01
      B00497S Remove in this Direction

      Disconnect the connector.

    2. Remove the 2 screws.

    3. Remove the cruise control main switch as shown in the illustration.

  4. REMOVE CRUISE CONTROL SWITCH WIRE


    1. A001X23

      Disconnect the connector to remove the cruise control switch wire from the cruise control main switch.