SPEED LIMITER SYSTEM Speed Limiter System does not Operate

DESCRIPTION

When the speed limiter is turned on using the speed limiter switch, the ECM illuminates the speed limiter indicator and activates the speed limiter system. Each function of the speed limiter system can be activated by operating the cruise control main switch. When the cruise control system is operating, the speed limiter system will not operate.

WIRING DIAGRAM

A005PW5E02
*a Speed Limiter Switch
*b ECCS
*c Steering Pad Switch Assembly
*d Spiral Cable Sub-assembly

PROCEDURE


  1. CHECK CRUISE CONTROL SYSTEM


    1. Turn the ignition switch to ON.

    2. Turn the cruise control on using the cruise control main switch.

    3. Check the operation of each function by operating the cruise control main switch.

      Click here

      OK
      Each function of the cruise control system operates normally.
      Result
      Proceed to
      OK
      NG

    NG

    GO TO CRUISE CONTROL SYSTEM Click here

    OK

  2. READ VALUE USING GTS (ASL SW)


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus : Powertrain / Engine / Data List / ASL SW.

    5. According to the display on the GTS, read the Data List.


      Powertrain > Engine > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      ASL SW Speed limiter switch signal ON or OFF

      OFF: Speed limiter switch off

      ON: Speed limiter switch on

      		 -

      Powertrain > Engine > Data List
      Tester Display
      ASL SW
      OK
      The Data List item ASL SW changes according to the operation of the switch.
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE ECM Click here

    NG

  3. CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - ECM)


    1. Disconnect the A38 ECM connector.

    2. Disconnect the F29 spiral cable sub-assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A38-22 (ASLM) - F29-4 (ASL) Always Below 1 Ω
      A38-22 (ASLM) or F29-4 (ASL) - Body ground Always 10 kΩ or higher
      F29-2 (ECC) - A38-41 (ECCS) Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. INSPECT SPIRAL CABLE SUB-ASSEMBLY


    1. Inspect the spiral cable sub-assembly.

      Click here

      Result
      Proceed to
      OK
      NG

    NG

    REPLACE SPIRAL CABLE SUB-ASSEMBLY Click here

    OK

  5. INSPECT STEERING PAD SWITCH ASSEMBLY


    1. Inspect the steering pad switch assembly.

      Click here

      Result
      Proceed to
      OK
      NG

    OK

    REPLACE ECM Click here

    NG

    REPLACE STEERING PAD SWITCH Click here