OIL PRESSURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY


    1. A001YG8C10
      *a Adhesive 1344
      *b Oil Inlet Port

      Apply adhesive to 2 or 3 threads of the oil pressure sender gauge assembly.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      Note


      • Do not apply adhesive to the oil inlet port of the oil pressure sender gauge assembly.

      • To prevent contamination by foreign matter, install immediately after applying adhesive.

    2. Using a 27 mm deep socket wrench, install the oil pressure sender gauge assembly.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine within 1 hour of installation.

    3. Connect the oil pressure sender gauge assembly connector.

  2. INSPECT FOR ENGINE OIL LEAK

    Click here

  3. INSTALL REAR ENGINE UNDER COVER RH

    Click here