STARTER(for Denso Made without Stop and Start System) COMPONENTS
Info Added 2017-10-06 
ILLUSTRATION
| *1 | NO. 1 ENGINE UNDER COVER | *2 | STARTER ASSEMBLY |
| *3 | TERMINAL CAP PROTECTOR | *4 | ENGINE WIRE |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |  |
N*m (kgf*cm, ft.*lbf): Specified torque |
ILLUSTRATION
| *1 | MAGNET STARTER SWITCH ASSEMBLY | *2 | STARTER ARMATURE ASSEMBLY |
| *3 | STARTER BRUSH HOLDER ASSEMBLY | *4 | STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY |
| *5 | STARTER COMMUTATOR END FRAME ASSEMBLY | *6 | STARTER YOKE ASSEMBLY |
| *7 | PLANETARY GEAR | *8 | RUBBER SEAL |
| *9 | STARTER DRIVE HOUSING ASSEMBLY | *10 | STARTER SHOCK ABSORBER |
| |
N*m (kgf*cm, ft.*lbf): Specified torque |  |
High-temperature grease |