STARTER(for Denso Made with Stop and Start System) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the starter assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system

Click here

Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

Click here

Replacement of starter assembly Clear Number of Starter Operations Stop and start system

Click here

*1: When performing learning using the GTS
Click here Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  4. REMOVE STARTER ASSEMBLY

    Tech Tips

    When the starter assembly is replaced, starter relay assembly must be also replaced.


    1. A001Y47

      Disconnect the starter assembly connector.

    2. A001SSG

      Disengage the clamp and remove the terminal cap protector from the terminal cap.

    3. A001UQ9

      Open the terminal cap.

    4. Remove the nut to disconnect the wire harness from terminal 30.

    5. A001TMH

      Remove the 2 bolts and starter assembly from the cylinder block sub-assembly.

      Note

      After the starter assembly is replaced, be sure to clear the number of starter operations stored in the engine stop and start ECU.

      Click here