STARTER(for Denso Made with Stop and Start System) COMPONENTS
Info Added 2017-10-06 
ILLUSTRATION
| *1 | NO. 1 ENGINE UNDER COVER | *2 | STARTER ASSEMBLY |
| *3 | TERMINAL CAP PROTECTOR | *4 | ENGINE WIRE |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |  |
N*m (kgf*cm, ft.*lbf): Specified torque |
ILLUSTRATION
| *1 | MAGNET STARTER SWITCH ASSEMBLY | *2 | PLANETARY GEAR |
| *3 | STARTER ARMATURE ASSEMBLY | *4 | STARTER ARMATURE PLATE |
| *5 | STARTER BRUSH HOLDER ASSEMBLY | *6 | STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY |
| *7 | STARTER COMMUTATOR END FRAME ASSEMBLY | *8 | STARTER YOKE ASSEMBLY |
| *9 | RUBBER SEAL | *10 | STARTER DRIVE HOUSING ASSEMBLY |
| *11 | PINION DRIVE LEVER | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque |  |
High-temperature grease |