INTAKE SYSTEM ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced when repairing air leaks in the intake system are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Air leak from intake system is repaired Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

CAUTION:


  • A005QA2

    When working near the engine room while the engine has started or the power source mode is ignition switch to ON (IG), do not touch the fan and generator V belt or rotating components such as the fan, etc.

  • Touching the fan and generator V belt or rotating components such as the fan, etc. could result in your hand or clothing getting caught and pulled in.

PROCEDURE


  1. INSPECT INTAKE SYSTEM

    Tech Tips

    Perform Inspection After Repair after repairing vacuum leaks in the intake system.

    Click here


    1. Check that there are no vacuum leaks at the points shown in the illustration.

      A001SPJ

  2. PERFORM INITIALIZATION


    1. Perform "Inspection After Repair" after repairing vacuum leaks in the intake system.

      Click here