FUEL SENDER GAUGE ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel sender gauge assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Simple intelligent parking assist system*1

Click here

Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Initialize back door lock Power door lock control system

Click here

*1: When performing learning using the GTS.

Click here

PROCEDURE


  1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

    Click here

  2. REMOVE FUEL SENDER GAUGE ASSEMBLY


    1. A001TBK

      Disconnect the fuel sender gauge assembly connector.

    2. Disengage the 3 clamps to disconnect the wire harness.

      Note

      Do not damage the wire harness.

    3. A001XIB

      Disengage the claw to remove the fuel sender gauge assembly from the fuel suction tube with pump and gauge assembly.

      Note

      Be careful not to bend the arm of the fuel sender gauge assembly.