CYLINDER BLOCK REPLACEMENT

PROCEDURE


  1. REPLACE RING PIN

    Note

    It is not necessary to remove a ring pin unless it is being replaced.


    1. A001TDJC05
      *a Upper Side
      *b Width
      *c Height
      *d Protrusion Height

      Using a plastic hammer, tap in the ring pins.

      Standard Ring Pin
      Item Height Width Protrusion
      Ring Pin 14.3 to 14.7 mm (0.563 to 0.579 in.) 12.9 to 13.0 mm (0.508 to 0.512 in.) 7.5 to 8.5 mm (0.295 to 0.335 in.)

  2. REPLACE STRAIGHT PIN

    Note

    It is not necessary to remove the straight pins unless they are being replaced.


    1. Using a plastic hammer, tap in the straight pins.

      A001X3AC01
      *a Front Side *b Lower Side
      *c Rear Side *d LH Side
      *e Width *f Height
      *g Protrusion Height - -
      Standard Straight Pin
      Item Height Width Protrusion
      Pin A 36 mm (1.42 in.) 10 mm (0.394 in.) 18.5 to 19.5 mm (0.728 to 0.768 in.)
      Pin B 12 mm (0.472 in.) 4 mm (0.157 in.) 5.0 to 7.0 mm (0.197 to 0.276 in.)
      Pin C 18 mm (0.709 in.) 8 mm (0.315 in.) 8 to 10 mm (0.315 to 0.394 in.)
      Pin D 22 mm (0.866 in.) 10 mm (0.394 in.) 11 to 13 mm (0.433 to 0.512 in.)
      Pin E 12 mm (0.472 in.) 4 mm (0.157 in.) 5.0 to 6.0 mm (0.197 to 0.236 in.)

  3. REPLACE STUD BOLT

    Note

    If the stud bolt is deformed or the threads are damaged, replace it.

    Tech Tips

    This procedure is for type A.


    1. Using an E6 "TORX" socket wrench, remove the stud bolts.

    2. A001TYUC02
      *a LH Side
      *b 16 mm (0.630 in.)
      *c 9 mm (0.354 in.)
      *d 27 mm (1.063 in.)

      Using an E6 "TORX" socket wrench, install the stud bolts as shown in the illustration.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  4. REPLACE CONNECTING ROD SMALL END BUSH


    1. A001T7WE03

      Using SST and a press, press out the connecting rod small end bush.

      SST
      09222-30010
    2. A001Y9AC09
      *a Oil Hole

      Align the oil holes of a new connecting rod small end bush and the connecting rod.

    3. A001T7WE02

      Using SST and a press, press in the connecting rod small end bush.

      SST
      09222-30010
    4. A001X90

      Using a pin hole grinder, hone the connecting rod small end bush to obtain the standard oil clearance between the connecting rod small end bush and piston pin.

      Standard Oil Clearance
      -0.001 to 0.005 mm (-0.0000394 to 0.0001968 in.)
    5. A001V9O

      Coat the piston pin with engine oil. Push the piston pin into the connecting rod with your thumb to check that the piston pin fits at normal room temperature.