CYLINDER HEAD GASKET INSTALLATION

Info Added 2017-10-06

PROCEDURE


  1. INSTALL CYLINDER HEAD GASKET


    1. A001U87C02
      *a Lot No.
      B00495X Front of Engine

      Place a new cylinder head gasket on the cylinder block sub-assembly with the Lot No. stamp facing upward.

      Note


      • Remove any oil from the contact surfaces.

      • Pay attention to the installation direction.

    2. A001WTRC02
      *1 Cylinder Head Gasket
      *a 4 to 7 mm (0.157 to 0.276 in.)
      *b 7 to 10 mm (0.276 to 0.394 in.)
      *c 6.5 to 8 mm (0.256 to 0.315 in.)
      B00495X Front of Engine

      Apply seal packing to the cylinder head gasket as shown in the illustration.

      Seal Packing
      Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent

      Note


      • Remove any oil from the contact surfaces.

      • Install the cylinder head gasket within 3 minutes and tighten the cylinder head set bolts within 15 minutes of applying seal packing.

  2. INSTALL CYLINDER HEAD SUB-ASSEMBLY

    Click here

  3. INSTALL VALVE STEM CAP

    Click here

  4. INSTALL VALVE LASH ADJUSTER ASSEMBLY

    Click here

  5. INSTALL NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY

    Click here

  6. INSTALL CAMSHAFT HOUSING SUB-ASSEMBLY

    Click here