CAMSHAFT POSITION SENSOR INSTALLATION

PROCEDURE


  1. INSTALL CAMSHAFT POSITION SENSOR (for Intake Side)


    1. A001YEOC05
      *1 O-ring

      Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

    2. Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • If the camshaft position sensor has been struck or dropped, replace it.

      • Make sure that the O-ring is not cracked or does not move out of place during installation.

    3. Connect the camshaft position sensor connector.

  2. INSTALL CAMSHAFT POSITION SENSOR (for Exhaust Side)


    1. A001YEOC05
      *1 O-ring

      Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

    2. Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • If the camshaft position sensor has been struck or dropped, replace it.

      • Make sure that the O-ring is not cracked or does not move out of place during installation.

    3. Connect the camshaft position sensor connector.

  3. INSPECT FOR OIL LEAK

    Click here

  4. INSTALL NO. 2 CYLINDER HEAD COVER

    Click here