PROCEDURE
INSPECT CONTINUOUSLY VARIABLE VALVE LIFT CONTROLLER ASSEMBLY
Connect the GTS to the DLC3.
Start the engine and warm it up.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VALVEMATIC(ENG ON).
| Tester Display |
|---|
| Activate the VALVEMATIC(ENG ON) |
Maintain an engine speed of 3000 rpm with the shift lever in P or N and the vehicle stationary.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Activate the VALVEMATIC(ENG ON) | Operates VALVEMATIC system to set valve lift to maximum or minimum | High/Low/OFF | Perform this test when the following conditions are met:
|
| Tester Display |
|---|
| Activate the VALVEMATIC(ENG ON) |
| OK |
|---|
| Change in Manifold Absolute Pressure during the Active Test |
| GTS Operation | Result |
|---|---|
| High |
|
| Low |
|
Tech Tips
If the vehicle is driven while there is a malfunction in the VALVEMATIC system and the valve lift amount is fixed at the minimum, the vehicle speed cannot exceed 30 to 60 km/h (19 to 37 mph).
If the intake valve advance angle is within the VALVEMATIC operation prohibition range, depending on the operating state of the VVT system, the Active Test "Activate the VALVEMATIC(ENG ON)" is prohibited. If the advance angle cannot be detected due to a malfunction in the VVT system, the Active Test "Activate the VALVEMATIC(ENG ON)" is prohibited.