CRANKSHAFT POSITION SENSOR INSTALLATION

PROCEDURE


  1. INSTALL CRANKSHAFT POSITION SENSOR


    1. A001TW1C01
      *1 O-ring

      Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

    2. Install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • If the crankshaft position sensor has been struck or dropped, replace it.

      • Make sure that the O-ring is not cracked or does not move out of place during installation.

    3. Connect the crankshaft position sensor connector.

  2. INSPECT FOR OIL LEAK

    Click here

  3. INSTALL REAR ENGINE UNDER COVER RH

    Click here

  4. INSTALL FRONT WHEEL RH

    Click here