WHEEL OPENING MOULDING(for Rear) REMOVAL

Info Added 2017-10-06

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE QUARTER OUTSIDE MOULDING

    Tech Tips

    When removing the quarter outside moulding, if the No. 1 body outside moulding pad (double-sided tape) is difficult to remove, heat the adhesive of the quarter outside moulding using a heat light.

    Standard
    Item Temperature
    Quarter Outside Moulding 20 to 30°C (68 to 86°F)

    CAUTION:


    • A005OUCC35
      *a Heated Part
      *b Heat Light

      Do not touch the heat light and heated parts, touching the heat light may result in burns.

    • Touching heated parts for a long time may result in burns.

    Note

    Do not heat the quarter outside moulding excessively.


    1. Remove the 3 screws and clip.

      A005OGE
    2. A005PN7C01
      B004987 Protective Tape

      Apply protective tape around the quarter outside moulding.

    3. A005OPRC02
      B00498X Place Hand Here
      B00497S Remove in this Direction (1)
      B0049AC Remove in this Direction (2)

      Disengage the claws by pushing the area indicated by the arrow in the illustration with a finger.

      Note

      To avoid damaging the claws, do not forcibly pull the quarter outside moulding.

    4. Disengage the clips and separate the double-sided tape to remove the quarter outside moulding.

      A005OFDC01
      *1 No. 1 Body Outside Moulding pad (Double-sided Tape) - -
      B00498X Place Hand Here B00497S Remove in this Direction