WHEEL OPENING MOULDING(for Front) INSTALLATION

Info Added 2017-10-06

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY


    1. B00497NC01
      B00497S Install in this Direction

      Install the pin hold clip as shown in the illustration.

      Note

      Insert the pin hold clip with the slot aligned vertically.

      Do not rotate the clip after inserting it.

      After installation, confirm that the slot is aligned vertically.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    2. B004966C01
      B00497S Install in this Direction

      Engage the clips and claws to install the front fender moulding sub-assembly as shown in the illustration.

    3. Install the 3 clips and 5 screws.

    4. Remove the protective tape.