REAR DOOR BELT MOULDING REMOVAL

Info Added 2017-10-06

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the rear door belt moulding removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision System
Initialize back door lock Power door lock control system

Click here

Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system

Click here


  • Rear door window regulator assembly

  • Rear door glass sub-assembly

  • Rear door glass run

 Initialize Power Window Control System

  • Auto up and down function

  • Jam protection function

  • Catch protection function

  • Remote control function

  • Key-linked function

  • Wireless transmitter-linked function

  • Key-off operation function

  • Window open warning function

Click here

*1: When performing learning using the GTS.

Click here

*2: w/ Stop and start system

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  4. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL

    Click here

  5. REMOVE REAR DOOR REAR FRAME BRACKET

    Click here

  6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  7. REMOVE REAR DOOR BELT REAR SEAL

    Click here

  8. REMOVE REAR DOOR GLASS INNER WEATHERSTRIP

    Click here

  9. REMOVE REAR DOOR BELT SEAL

    Click here

  10. DISCONNECT REAR DOOR WEATHERSTRIP


    1. Disconnect the rear door weatherstrip until the screw of the door window rear lower sub-assembly is visible.

  11. REMOVE REAR DOOR SERVICE HOLE COVER

    Click here

  12. REMOVE REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY

    Click here

  13. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  14. REMOVE REAR DOOR FRAME GARNISH

    Click here

  15. REMOVE REAR DOOR GLASS RUN

    Click here

  16. REMOVE REAR DOOR QUARTER WINDOW GLASS

    Click here

  17. REMOVE REAR DOOR BELT MOULDING ASSEMBLY


    1. A005Q82C01
      B004987 Protective Tape

      Apply protective tape around the rear door belt moulding assembly.

    2. A005PNDC01
      B00497S Remove in this Direction

      Disengage the claws to remove the rear door belt moulding assembly as shown in the illustration.