HEADLIGHT ASSEMBLY(for LED Headlight) REMOVAL

Info Added 2017-10-06

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the headlight assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Headlight ECU sub-assembly LH

  • Synchronize vehicle information

  • Initialize headlight ECU sub-assembly LH

 Automatic headlight beam level control system

Click here

Note

If the headlight assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  2. REMOVE HEADLIGHT ASSEMBLY


    1. A005PH1C02
      B004987 Protective Tape

      Apply protective tape around the headlight assembly as shown in the illustration.

    2. A005OEYC01
      *a Connector Lock Lever
      B00497S Remove in this Direction

      Disengage the claw, pull down the connector lock lever as shown in the illustration to disconnect the connector.

    3. A005OLQ

      Remove the bolt and 3 screws.

    4. A005PC7C02
      B00497S Remove in this Direction

      Remove the headlight assembly as shown in the illustration.