ENGINE COOLANT TEMPERATURE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine coolant temperature sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of engine coolant temperature sensor Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  2. DRAIN ENGINE COOLANT

    Click here

  3. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. A001W5X

      Disconnect the engine coolant temperature sensor connector.

    2. A001U56

      Remove the clip and engine coolant temperature sensor from the water outlet.

      Note

      If the engine coolant temperature sensor has been struck or dropped, replace it.