THROTTLE BODY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the throttle body with motor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of throttle body with motor assembly Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

Cleaning the deposits from the throttle body with motor assembly

PROCEDURE


  1. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  2. DRAIN ENGINE COOLANT

    Click here

  3. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    1. A001VCUC01
      *1 No. 1 Water By-pass Hose
      *2 No. 2 Water By-pass Hose

      Disconnect the throttle body with motor assembly connector.

    2. Slide the 2 clips and disconnect the No. 1 water by-pass hose and No. 2 water by-pass hose from the throttle body with motor assembly.

    3. A001W93

      Remove the 2 bolts and 2 nuts.

    4. A001TXO

      Using an E6 "TORX" socket wrench, remove the 2 stud bolts.

      Note

      Do not drop the throttle body with motor assembly.

    5. Separate the intercooler assembly and remove the throttle body with motor assembly from the intake manifold.

      Note

      If the throttle body with motor assembly has been struck or dropped, replace it.

  4. REMOVE THROTTLE BODY GASKET


    1. A001YFKC01
      *a Intercooler Assembly Side
      *b Intake Manifold Side

      Remove the throttle body gasket from the intercooler assembly.

    2. Remove the throttle body gasket from the intake manifold.