CAMSHAFT OIL CONTROL VALVE(for Exhaust Side) INSTALLATION

PROCEDURE


  1. INSTALL CAMSHAFT TIMING GEAR BOLT

    Note

    There are different types of camshaft timing gear bolts. Make sure to check the identification mark to determine the tightening torque.

    A005OIBC10
    *a Identification Mark
    Identification Mark
    Item Identification Mark
    Type A B
    Type B G

    1. Make sure that the No. 1 cylinder is at the TDC/compression.

      Tech Tips

      Check that the cutout of the camshaft timing gear assembly is at the top and align the timing mark (cutout) of the crankshaft pulley with the protrusion on the timing chain cover assembly.

    2. A005Q3T

      Apply engine oil to the areas of the camshaft timing gear bolt shown in the illustration.

    3. While holding the crankshaft pulley, install the camshaft timing gear bolt.

      Torque:
      for Type A
      120 N*m  { 1224 kgf*cm, 89 ft.*lbf }
      for Type B
      95 N*m  { 969 kgf*cm, 70 ft.*lbf }

      Note


      • If the camshaft timing gear bolt has been struck or dropped, replace it.

      • Do not use an impact wrench.

      • If there is any abnormal resistance when installing the camshaft timing gear bolt, loosen it and make sure that the No. 1 cylinder is at TDC/compression, and then install the camshaft timing gear bolt again.

  2. INSTALL CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (for Exhaust Side)

    Click here

  3. INSPECT FOR ENGINE OIL LEAK

    Click here

  4. INSTALL REAR ENGINE UNDER COVER RH

    Click here

  5. INSTALL FRONT WHEEL RH

    Click here