3ZR-FAE BATTERY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the battery removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Simple intelligent parking assist system*1

Click here

Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Initialize back door lock Power door lock control system

Click here

*1: When performing learning using the GTS.
Click here Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


    1. A001VBC

      Loosen the nut and disconnect the cable from the negative (-) battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

      Click here

  3. REMOVE BATTERY


    1. A001VEN

      Disengage the 2 claws to remove the fusible link cover.

    2. A001VVQ

      Loosen the nut.

    3. A005OOV

      Disengage the clamp and disconnect the cable from the positive (+) battery terminal.

    4. A001WY0

      Remove the battery insulator from the battery.

    5. A001SSY

      Remove the bolt and No. 2 battery clamp.

    6. A001T3S

      Remove the battery from the vehicle.