ROOF GARNISH REMOVAL

PROCEDURE


  1. REMOVE REAR ROOF DRIP SIDE FINISH MOULDING SUB-ASSEMBLY LH


    1. A003P0JC01
      B006IOI Protective Tape

      Apply protective tape around the rear roof drip side finish moulding sub-assembly LH.

    2. A003K01C01
      B006IFV Remove in this Direction

      Using a moulding remover, disengage the 3 clips as shown in the illustration to remove the rear roof drip side finish moulding sub-assembly LH.

    3. A003MXE

      Remove the 2 clips from the rear roof drip side finish moulding sub-assembly LH.

    4. A003MPG

      Remove the cap and gasket.

  2. REMOVE REAR ROOF DRIP SIDE FINISH MOULDING SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

  3. REMOVE ROOF HEADLINING ASSEMBLY

    Click here

  4. REMOVE ROOF TOP MOULDING SUB-ASSEMBLY


    1. Remove the 7 nuts and roof top moulding sub-assembly as shown in the illustration.

      A003O6NC01
      B006IFV Remove in this Direction - -