HEIGHT CONTROL SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear height control sensor sub-assembly LH removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear height control sensor sub-assembly LH Initialize No. 1 headlight ECU sub-assembly LH

  • Automatic headlight beam level control system

  • Adaptive high beam system*1

Click here

*1: w/ Adaptive High Beam System

PROCEDURE


  1. REMOVE REAR WHEEL (for LH Side)

    Click here

  2. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    1. A003NVGC01
      *a Clamp
      *b Guide

      Disconnect the connector.

    2. Disengage the clamp.

    3. Remove the 2 bolts.

    4. Disengage the guide to remove the rear height control sensor sub-assembly LH.

      Note

      If the rear height control sensor sub-assembly LH has been struck or dropped, replace it with a new one.